Hydraulic Recovery Winch




  1. Powered by a PTO/power take off unit driven pump
  2. Fast and variable recovery speeds for high work rate
  3. Highly efficient and reliable torque motor
  4. 2 stage planetary gear train for greater pulling force
  5. Easy to turn T-handle for rapid wire rope payout
  6. Drag brake and over-centre valve providing full 100% braking
  7. EN 14492-1 supported: 10:1 D/d ratio and 2:1 wire rope strength allow for severe duty car and commercial recovery
  8. Meet SAE J706, CE Machinery Directive 98/37/EC, and REMSA Standards



Rated line pull 3,630 kg (SAE J706 rating);
3,560 kg (EN 14492-1 rating)
Line Speed 15 m/min at 60 lt/min
Operation Pressure 150 bar
Gear reduction 16 : 1 planetary
Gear type 2 stage planetary gear train
Winch construction Aluminum die cast housings with steel drum
Brake Spring applied drag brake together with over-centre valve supplied
Clutch (freespooling) Rotating ring gear
Rotation of winch Wire rope shall be under-wound orientation only
Drum diameter x length (Std. Drum) 90 mm x 190 mm
Drum diameter x length (Long Drum) 90 mm x 253 mm
Wire rope recommended 10 mm diameter 1,960 N/mm2 grade
40 m (standard drum);
55 m (long drum)
  A minimum breaking strength of 69.8 KN is required

Standard Accessories

  • Roller fairlead
  • Over-centre valve

Optional Accessories

  • Cable tensioner
  • Air clutch


  • The winch is not intended to be used in any manner for the movement or lifting of personnel.
  • The rated line pull shown is based on the first layer of rope on the drum.
  • The rope winding on the drum shall remain 5 wraps from the drum.


Each new winch is guaranteed against defects in workmanship and material defects for a period of twelve months from date of purchase.

NSW/ACT 1300 555 456  |  QLD/NT 07 4047 8900  |  VIC/TAS 03 9762 1200  |  SA 08 8344 6444  |  WA 08 9317 2344